Honda Grom banner

Tie Down Points

8130 Views 5 Replies 4 Participants Last post by  pocketrocket
Im putting the grom in my van. I placed the hooks right in front of the rear foot pegs on each side and anchored them behind the rear tjre.. I put one more strap thru the fron rim and anchored it to a point forward of the bike. Im a newbie to tie downs. Do u think this 3 point systm should work.

Btw, I tightened down just enough to take most of the weight off the kickstand. But it still leans left. I did that in case any of the straps came loose ane hopefully it would find the kickstand.

Does anyone see a problem with this approach? I thought about strapping each handlebar to the ceiling of the van using the top of the seat belt anchors.
1 - 1 of 6 Posts
Im putting the grom in my van. I placed the hooks right in front of the rear foot pegs on each side and anchored them behind the rear tjre.. I put one more strap thru the fron rim and anchored it to a point forward of the bike. Im a newbie to tie downs. Do u think this 3 point systm should work.

Btw, I tightened down just enough to take most of the weight off the kickstand. But it still leans left. I did that in case any of the straps came loose ane hopefully it would find the kickstand.

Does anyone see a problem with this approach? I thought about strapping each handlebar to the ceiling of the van using the top of the seat belt anchors.

be careful strapping anything to the pieces of the rear foot pegs.. i have seen a few people who used that area as anchor points and it broke.. i put a strap on both side of the handlebar and then one on the rear tire when i had it strapped to a rack for the back of my jeep..
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top