Agreed, polishing a steel swing arm is a waste. If it were aluminum, then you'd be ok.
Sent from my iPad using HondaGrom.net
Sent from my iPad using HondaGrom.net
Started the process to polish the spare swing arm, pic
3
I went to HFT"Harbor Freight Tools" and picked up some buffing pads for my drill and also 6" polishing buffing pad for my grinding table top tool. I also picked up a Grey wax for cleaning and polishing the metal swing arm.
took some pic after about 1.5 hrs of drill polishing, I will start again tomorrow after I pick up more drill buffing pads.
I have to use some dermal tool for the tight spots
took some pic after about 1.5 hrs of drill polishing, I will start again tomorrow after I pick up more drill buffing pads.
I have to use some dermal tool for the tight spots
