Honda Grom banner
1 - 20 of 44 Posts

· Registered
Joined
·
550 Posts
Nice, who made them for you and cost if you don't mind?

Sent from my A500 using HondaGrom.net mobile app
 

· Registered
Joined
·
946 Posts
Those are really nice, bet they cost an arm and leg though being cut from billet. Doesn't 1 blank billet cost over $400 alone? Last year at a honda mini meet there was a guy german guy there selling Monkey rims, they were the nicest ones id ever seen, but he was asking around 1200 euro each.


Sent from my iPad using HondaGrom.net
 

· Vendor
Joined
·
2,186 Posts
I wasn't knocking them. They look great, but a billet is by definition a solid chunk. Those are two piece, welded, and in fact, you can even see the decals on them from the manufacturer. Again, none of that is bad. If it were a custom from a billet blank, you'd be paying $1000 per. He's not doing anything wrong. It only makes sense to buy a blank from a wheel manufacturer. They know what they're doing, and it saves him / you a lots of material cost, run time, and money....
 

· Registered
Joined
·
201 Posts
Discussion Starter · #17 ·
I wasn't knocking them. They look great, but a billet is by definition a solid chunk. Those are two piece, welded, and in fact, you can even see the decals on them from the manufacturer. Again, none of that is bad. If it were a custom from a billet blank, you'd be paying $1000 per. He's not doing anything wrong. It only makes sense to buy a blank from a wheel manufacturer. They know what they're doing, and it saves him / you a lots of material cost, run time, and money....
Oh I know and I know you weren't knocking I just was unaware of the material used.
 
1 - 20 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top