Honda Grom banner
1 - 5 of 5 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 · (Edited)
So I ordered some G-Craft parts for my Monkey:
  • G-Craft billet brake pedal
  • G-Craft billet change pedal
  • G-Craft shift guide
  • G-Craft Axle collar
Nice looking stuff and made with care. Thing is, the billet brake and change pedal came partially installed (bolted down). I figured this was done to help me and didn’t pay attention to how tight the where bolted down. After installing the parts I made a little test drive. At home I noticed some play at both pedals. Looking closer I noticed that all bolts that where factory set already came loose and I almost lost one. I can’t tighten them when on the bike. This means I have to install them all over and tighten all bolts. This is a shame, and unnecessary if I checked the torque before installing. So when doing these be sure to check!

The shifting was very nice BTW, nice tight clicks.
 

·
Registered
Joined
·
107 Posts
Discussion Starter · #5 ·
I redone them yesterday and added some blue 243 to be sure. Really like the shifting with these parts 😊
 
1 - 5 of 5 Posts
Top