Search Results for ‘maintenance’

I took the wheels off to have a shop put new tires (Shinko 428) on them. I noticed that the lubricant around the axles/wheels bearings is blackened with grime. Is there any good reason I shouldn't use a bit of leftover 10W-40 to lubricate the friction/load bearing parts when I put it back...

Will ship same day if time allows. Many references on here and on the Grom performance page on facebook. Can part items out but they will cost more. Fly wheel holder , flywheel gear removal tool, Motion pro gear jammer , Valve adjustment tool and the oil spinner socket to remove the oil spinner...

Most of the spark plug threads here are for big bores or setups where the stock heat range is too hot. NGK also has an iridium in the stock heat range that does not tend to cross-reference with the stock plug, CR6EIA-9. I went with heat range 6 because most of my riding is commuting: low engine...

Hello Fellow Grommers, I just had to replace my rear wheel yesterday, long story short, taking off and putting back on was no problem. The problem here is when I tighten my rear axle nut, its screws the adjustment up. The plates where the the adjustment nut sits pretty much falls and hangs...