Thanks for the tip!
This is a discussion on Flasher Relay for Any Type of Blinkers within the Grom How-To's and Guides forums, part of the Honda Grom Forums category; Here's a simple flasher relay that will work for any combination of LED and incandescent bulbs WITHOUT the need for resistors. This one is a ...
Here's a simple flasher relay that will work for any combination of LED and incandescent bulbs WITHOUT the need for resistors.
This one is a direct plug in, but you lose the clicking sound:
CF12ANL-01 LED Bulb Electronic Flasher | Flashers & Load Resistors | Car Bulb Installation Supplies | LED Car Bulbs | Super Bright LEDs
I elected to use this one that clicks, but requires installing a ground wire to the E pin:
CF13JL-02 LED Bulb Electronic Flasher | Flashers & Load Resistors | Car Bulb Installation Supplies | LED Car Bulbs | Super Bright LEDs
I confirmed this works on my stock flashers and also on a friend's who's running half LED, half stock. But this will work with virtually any setup. The new relay is tie wrapped in place as shown. The yellow wire taps into the green ground wire on the headlight connector and connects to the E pin of the relay. Hope this helps.
Thanks for the tip!
Sold the Grom and riding the FZ-07 nowadays.
This should work for all 4 LEDs too.
2014 Honda Grom 170
1999 Honda Nighthawk 750
2002 Honda XR70R w/BBR 88 big bore
2006 Honda CRF230F
2007 Honda CRF50F (son's)
Thanks, been struggling with mine trying all different combo's of flashers and resistors.
My front turn signals are LED and rear are stock, i have not put a different relay in yet and my blinkers just stay solid. will this relay make them blink properly?
+1 for the EL12
Paddle, paddle, paddle little Grom.
Last edited by Brom; 09-19-2013 at 11:35 PM.
Why this may be true you have to order it. for people like me i have to have it yesterday i can go to any parts store and pick up a el12. Your suggested flasher is a great option for weird combos. But even front and rear led combos work with a el12. It did not work in my set up because my supplyed rear blinkers did not have built in resistors like my front did. I had to add 50 ohm resistors in my set up.
I would say if your running a normal blinker set up including leds for specificly motorcycles a el12 will be you best buy
Anything custom buy the one you found and give it a shot. Good find it gives us all more options
****** i am not a expert in electrical just like playing around with it wouldnt belive half the stuff i say ***
Last edited by jmurray192; 09-20-2013 at 12:07 AM.